Repair ram slot


Instruction Sheet Date: 11/7/96, instruction sheet K6855238, throttle cable and bellcrank lever package.
(skipped) Reset the clock and radio.
Check Drum Sensitivity microswitches.
Reseat connectors J002 on the DC Controller and J601 on the LaserDrive PCA.Remove optional I/O PCA, then re-test.Installing memory, for these 20-inch and 17-inch models.Paper is jammed somewhere in the paper path or a sensor flag is stuck.Inspect Fiber-Optic Cable between Laser/Scanning Assembly and DC Controller.Remove EIO cards, perform cold reset.Insert the opposite end of the throttle cable through the dash panel opening until the tabs on the cable housing retainer snap into place (Fig 1).



Computer power is off.
Replace if either is bad.
Reset by pressing the continue key.
62.x memory error 4000/4050/4100/5000/8000/8100 only:.x bingo moron colectivos where x Dimm slot, Check/replace dimms.
79 service (Document Error).Refer to the 1997 service manual pages 14-133 and 14-134 for TPS adjustment procedures.If you have the older cable without a plastic sheath (i.e.X1: Beam detect malfunction.Replace Cable, Laser/Scanner to DC Controller cable.PCL file being sent to printer while in PostScript mode.57 error II, iiid Only:.23 I/O NOT ready.Check connectors J204 and J6 on DC Controller and conenctor at Fan.


Sitemap